09160374 (currently 0.00053247 BTC)īased off of the current NMC exchange rate, my erupters have generated a total of 0.03101768-BTC in under 100 days.Īt the current BTC/USD exchange rate of $578.86, I've been able to generate $17.96 USD. Altogether, a daily profit of about $0.15 per day USD.ĤxUSB erupters + $42.94 (USB Hub & Fan) + S&H = $106.16 In addition to the BTC, I generated about $0.03 in NMC. All the other non scrypt coins seem to be dead apart from terracoin. With the 4 erupters running 24/7, I use about $0.02/USD of electricity while generating on average $0.12-$0.16 in bitcoin per day. I chose mining because it seamlessly allows you to mine namecoin through the same port/pool.ĭon't use bitminter's flash miner if you want to mine alt coins with your gpus while going after bitcoin with the ASIC cards (it doesn't play nice if you have wallets running or cgminer working and you'll get a lot of rejects)- but by using a command line miner for sha-256, I can also run guiminer-scrypt or cgminer to hash out alt coins. I've had a constant 1.3-1.4Gh/s with these USB erupters, peaking at 2.2Gh/s (but that's an anomaly and not constant) I use bfgminer and set them up to run They're super easy to use once you get the drivers set up and understand how to mine. Miner with APW7 Power Supply Setup Guide - ASIC USB Block Erupter Bitcoin Miner. I purchased 4 erupters back in November 2013- just to run beside my 4x5970s and 3x7950s, it was an experiment and at the time I was pretty new to mining in general.Ĥ-erupters with 92mm cooling fan and powered-USB hub. Antminer S9 Profitability Mining Algorithm: SHA-256 Manual Antminer S1. Is there a way I can do this I have got them working with BFG miner and followed the steps including the xnsub step. Novelty / colectors item USB Block Erupter Specs Interface: USB Type of Miner: ASIC Power use: 5v 500mA 2.5 watts Speed: 333 MH/s Size: Wide usb, size of memory stick Temperature: not given BTC per day: not given (varies based on pool) USB Block Erupter ACTUAL Performance Power use: 5v 420mA 2. I just upgraded to an AntMiner U2 and used this guide to configure it, and it seems to be running ok around 2Gh/s, but the third number is always much lower and my pool reports much much lower speeds than even my USB Block. Realizing I'm very tardy to this post, I'd like to throw out this update for those currently googling this question. Hello, I have a few usb sha-256 block erupters that I would like to use with nicehash. I've been running a single USB Block Erupter with BFGminer for several weeks and have seen ICA 0: with 337/332/355Mh/s.
0 Comments
Leave a Reply. |